| [c5c522c] | 1 | # Master configuration file for the LXC driver. |
|---|
| 2 | # All settings described here are optional - if omitted, sensible |
|---|
| 3 | # defaults are used. |
|---|
| 4 | |
|---|
| 5 | # By default, log messages generated by the lxc controller go to the |
|---|
| 6 | # container logfile. It is also possible to accumulate log messages |
|---|
| 7 | # from all lxc controllers along with libvirtd's log outputs. In this |
|---|
| 8 | # case, the lxc controller will honor either LIBVIRT_LOG_OUTPUTS or |
|---|
| 9 | # log_outputs from libvirtd.conf. |
|---|
| 10 | # |
|---|
| 11 | # This is disabled by default, uncomment below to enable it. |
|---|
| 12 | # |
|---|
| 13 | #log_with_libvirtd = 1 |
|---|
| 14 | |
|---|
| 15 | |
|---|
| 16 | # The default security driver is SELinux. If SELinux is disabled |
|---|
| 17 | # on the host, then the security driver will automatically disable |
|---|
| 18 | # itself. If you wish to disable QEMU SELinux security driver while |
|---|
| 19 | # leaving SELinux enabled for the host in general, then set this |
|---|
| 20 | # to 'none' instead. |
|---|
| 21 | # |
|---|
| 22 | #security_driver = "selinux" |
|---|
| 23 | |
|---|
| 24 | # If set to non-zero, then the default security labeling |
|---|
| 25 | # will make guests confined. If set to zero, then guests |
|---|
| 26 | # will be unconfined by default. Defaults to 0. |
|---|
| 27 | #security_default_confined = 1 |
|---|
| 28 | |
|---|
| 29 | # If set to non-zero, then attempts to create unconfined |
|---|
| 30 | # guests will be blocked. Defaults to 0. |
|---|
| 31 | #security_require_confined = 1 |
|---|
